Warnings:
1)Always disconnect the battery when dealing with Airbags.
2) I am not responsible if you damage your car or yourself during this install
1)Always disconnect the battery when dealing with Airbags.
2) I am not responsible if you damage your car or yourself during this install
I am assuming if your doing this DIY you have already figured out how to remove the seats and disconnected the the battery and the wires connected to the seat.
First thing you need is a Resister with a resistance of 3.3 Ohms.
[ame="http://www.amazon.com/3-3-Ohm-Flameproof-Resistor-Pcs/dp/B0002ZP0US/ref=sr_1_1?ie=UTF8&qid=1346546875&sr=8-1&keywords=3.3ohm+resistor"]Amazon.com: 3.3 Ohm 1W Flameproof Resistor 10 Pcs.: Electronics[/ame]
Locate the yellow harness .
You will notice that there are only 2 wires connected to the harness but are 4 holes (sorry the picture doesn't really show it, i'll try to get a better one before Install the seat tomorrow morning), you want to plug the resistor into the bottom two holes.
No it does not matter which side of the resistor you plug into which hole.
See no light
Thanks to Ricepuddin